Lab Guidance Videos

School of Electrical Engineering and Telecommunications

University of New South Wales

Sydney, Australia

Please right click below link to save the video file to your hard disk

Low Resolution Videos (10 - 70MB)
Multimeter - 1 Introduction	Multimeter - 2 Measuring Resistance	Multimeter - 3 Measure Voltage	Multimeter - 4 Measure Current
Power Supply - 1 Introduction	Power Supply - 2 Current Limiting	Power Supply - 3 Series Mode	Power Supply - 4 Parallel Mode
Signal Generator - 1 Introduction	Signal Generator - 2 Displaying a Waveform	Signal Generator - 3 Amplitude Attenuation	Signal Generator - 4 Duty Cycle
Signal Generator - 5 Offset	Signal Generator - 6 CMOs_TTL Terminal
Oscilloscope - 1 Introduction	Oscilloscope - 2 Adjusting Scales	Oscilloscope - 3 Vertical Axis	Oscilloscope - 4 Coupling
Oscilloscope - 5 Triggering	Oscilloscope - 6.1 Using Two Channels	Oscilloscope - 6.2 Adjusting Scales with 2 Channels	Oscilloscope - 6.3 Triggering with 2 Channels
LED Circuit - 01	LED Circuit - 02	Inverting Op Amp	Breadboard
Frequency Response RC RC - 01

High Resolution Videos (150 - 700MB)
Multimeter - 1 Introduction	Multimeter - 2 Measuring Resistance	Multimeter - 3 Measure Voltage	Multimeter - 4 Measure Current
Power Supply - 1 Introduction	Power Supply - 2 Current Limiting	Power Supply - 3 Series Mode	Power Supply - 4 Parallel Mode
Signal Generator - 1 Introduction	Signal Generator - 2 Displaying a Waveform	Signal Generator - 3 Amplitude Attenuation	Signal Generator - 4 Duty Cycle
Signal Generator - 5 Offset	Signal Generator - 6 CMOs_TTL Terminal
Oscilloscope - 1 Introduction	Oscilloscope - 2 Adjusting Scales	Oscilloscope - 3 Vertical Axis	Oscilloscope - 4 Coupling
Oscilloscope - 5 Triggering	Oscilloscope - 6.1 Using Two Channels	Oscilloscope - 6.2 Adjusting Scales with 2 Channels	Oscilloscope - 6.3 Triggering with 2 Channels
LED Circuit - 01	LED Circuit - 02	Inverting Op Amp	Breadboard
Frequency Response RC RC - 01

---

Please read this disclaimer
Further Information: EE&T School Office